Holybro PM07 Power Module (14S)

Description:

Holybro PM07 Power Module (14S) supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power & signal distribution for up to 8 ESCs.

PM07 has two 5.2V power output port that can provide redundant power to the flight controller, with independent circuits, BEC IC and circuitry.

It is also great for flight controller that do not have built-in servo header pins like the Pixhawk 6C & Pixhawk 4. It comes with pre-soldered wires, capacitor, and XT60 connector.

Follow us World Drone Market on YouTube to view more videos about the Holybro Product.

Specifications:

Input voltage: 2S-14S
PCB Cont. Current Rating: 90A
PCB Burst Current Rating: 140A (<60 Sec)
Output: DC 5.2V & 3A Max
Voltage Divider: 18.182
Amperes per Volt: 36.364

Please Note:

The PM07 12S version has reached end of life. Instead, the 14S version takes its place.
The board ships with a pre-soldered XT60 plug and 12AWG wire. Specifically, these components support 30A continuous current and 60A burst current for less than 60 seconds. However, you must upgrade the plug and wire gauge if your application draws higher currents.
This PM07 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D).