Holybro PM02 V3 Power Module

Holybro PM02 V3 Power Module (12S)

Holybro PM02 V3 Power Module provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection.

Follow us World Drone Market on our YouTube to view more about the PM02 V3 12S Power Module.

PM02 V3 Power Module Specification:

• Input Voltage: 2S-12S
• PCB Cont. Current Rating: 60A
• PCB Burst Current Rating: 100A (<60 Sec)
• Max Current Sensing: 120A
• Output: DC 5.2V & 3A Max
• Voltage Divider: 18.182
• Amperes per Volt: 36.364
• Weight: 20g

Please Note: 

• The board comes with a pre-soldered XT60 plug and 12AWG wire. Specifically, they handle 30A continuous current and 60A burst current (< 60 seconds). Furthermore, you need to adjust the plug type and wire gauge if your setup draws higher current. For guidance, you can check this chart.
• This PM02 power module outputs analog data. As a result, it cannot work with Pixhawk 5X or 6X. Instead, those flight controllers require a digital power module such as the PM02D.