SPECIFICATIONS
- Item: TX16S MKII Radio
- Size: 287*129*184mm
- Weight: 750g (without battery)
- Frequency: 2.400GHz-2.480GHz
- Internal RF Options: 4-in-1 or ELRS 2.4GHz
- Supported Protocols: Module dependent
- Firmware: EdgeTX (Supports OpenTX)
- Voltage Range: 6.6-8.4V DC
- Control distance: Max 2km
- Channels: Max 16 channels (RX dependent)
- Working current: 400mA
- TFT Display: 4.3-inch full-color touch
- Gimbals: V4 Hall gimbals (AG01 Optional)
- External module: JR compatible
- Upgrade Method: USB / SD card & EdgeTX Companion PC software
MODEL & PROTOCOL SELECTION
Multi-protocol Module
A wide variety of modules is available for TX16S MKII units with the 4-in-1 module. To find out whether a certain protocol would work with your radio, please visit the multi module website.
Please note that new protocols will be constantly updated and added to the latest firmware. Some new protocols may require firmware upgrades
- Long press the MDL button to enter the model settings, select MULTI in the SETUP page, and select the protocol to be used in the sub-options. The system will automatically turn on the corresponding RF module according to the RF protocol you selected.
- Bind [BND] is used to start the binding process.
- Range [RNG] button can reduce the power to 1/30 to facilitate testing of remote-control distance.
ATTENTION
4in1/CC2500 Users: The receiver you are using may require frequency tuning, follow this link to tune before flight.
ExpressLRS Version
TX16S MKII ExpressLRS units are equipped with an internal ExpressLRS module, Transmitting power Default 100mW. In non-extreme circumstances, 100mW output at 500Hz update rate is recommended, as higher RF output and update rates may significantly reduce battery life and generate excessive heat.
BIND INSTRUCTIONS
1. TURN OFF the transmitter.
2. Cycle power to the receiver 3 times, the receiver LED will flash twice – indicating bind mode.
3. TURN ON the transmitter, long press the SYS button and choose ExpressLRS LUA under the TOOLS menu. Scroll to [Bind] and press enter.
4. The LED on the receiver should now be solid, indicating a successful bind.
Leave a comment
You must be logged in to post a comment.